I sure hope you are wrong about that number. You know, in 1958 I had a
Techraft Converter that had a noise figure of 7dB and my quite excellent V/U
upgrade is somewhere around 1 dB and my dedicated pre-amp is somewhere
close to 0.4 dB. A noise figure of 4 in 2012 would rate somewhere between
wretched and miserable!
Lee K9WRU
----- Original Message -----
From: "Brian Lloyd" <[email protected]>
To: "Ron Stockton" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, May 22, 2012 11:23 PM
Subject: Re: [FlexEdge] Flex 6000 MDS
On Tue, May 22, 2012 at 8:19 PM, Ron Stockton <[email protected]> wrote:
Before I jump in and place a pre-order, can you provide a hint of the
Minimum Discernible Signal (MDS) level on 30 MHz? This was a conspicuous
TBD
on the preliminary spec sheet.
Gerald mentioned in a posting that the performance on 2m will be about 4dB
NF. Since it is the same receiver, I would suspect that 10m performance
will be at least as good.
--
Brian Lloyd, WB6RQN/J79BPL
3191 Western Dr.
Cameron Park, CA 95682
[email protected]
+1.767.617.1365 (Dominica)
+1.916.877.5067 (USA)
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
