When prompted, you should see 2 folders to select from. One is a
checked folder (contains "chk") that contains a vCOM.sys for debugging
the driver. The other is the version that you probably want to run
("fre", I think it says).
See complete instructions in our operating manual and at
www.hamsdr.com/dnld.aspx?id=31.
Eric Wachsmann
FlexRadio Systems
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
> radio.biz] On Behalf Of ab7r
> Sent: Monday, September 05, 2005 3:49 PM
> To: Flexradio@flex-radio.biz
> Subject: [Flexradio] More help please
>
> Tried to install the VCom software and got a message vCOM.sys on N8VB
vCOM
> multiportserial drivers is needed.....then asked to point to where
they
> are.
> But they are not in the folder setup after the zip file was extracted.
> Can
> someone help point to the right location?
>
>
> Also....while reviewing the PowerSDR console....is there a way to
increase
> or decrease the range of the adapter display. Say if I want to see a
> narrower or wider bandwidth. I know the max is 48Khz due to SC
> limitations,
> but can't that be decreased too?
>
> Tnx again and hope everyone is have a fine holiday. The fog finally
> lifted
> here on Whidbey Island and looks like its a nice day!
>
> 73
> Greg
> AB7R
>
>
>
> _______________________________________________
> FlexRadio mailing list
> FlexRadio@flex-radio.biz
> http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
