Simon, You're right, HRD shows all the virtual COMs I set up. Unfortunately, nothing else sees the other ends. I'm particularly confused since PowerSDR is a brand new build and I would have thought it properly enumerated all the available Ports. So far, MixW, HRD and Hyperterminal see all the Ports, PowerSDR sees only the four real Ports. I must be doing something wrong.
Chris - AE6VK -----Original Message----- From: Simon Brown (HB9DRV) [mailto:[EMAIL PROTECTED] Sent: Sunday, April 02, 2006 1:02 AM To: FlexRadio Subject: Re: [Flexradio] [hpsdr] vCOM Virtual Serial Driver - NewInstallerand Configurator FWIW Ham Radio Deluxe will correctly show them, so you can use this as a check if needed. I'm sure other programs show them as well. Simon Brown --- http://blog.hb9drv.ch/ ----- Original Message ----- From: "Christopher T. Day" <[EMAIL PROTECTED]> > > You're sure this isn't an April Fool's Joke? No doubt I'm the fool, but > shouldn't the virtual COM ports I set up in vCOM show up as selectable > ports on the CAT Control Port dropdown list? All I ever see in the > dropdown list are a fixed set of four ports all below 8. What am I > missing? Thanks. > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com