Try renaming your database (the file that is a .mdb) and create a new one without importing. You will need to recalibrate.
Mike - AA8K Mike Monnier wrote: > Hello Folks, > > I have been looking forward to 1.10.1 for some time. I don't use beta > versions, only official releases. > > I downloaded and installed 1.10.1 and imported the database from 1.8.0. > > When I turn on PowerSDR 1.10.1 it looked as if the rig was in transmit with > HIGH SWR light on and 578 watts. I shut it down right away. I checked > through all settings on the setup menus of both 1.8.0 and 1.10.1 and they > are the same. 1.8.0 works fine but 1.10.1 now dose nothing. The receiver > pumps from a high noise floor to a higher straight line and back, no sound. > It looks like I was able to calibrate the PA. I get no warnings. > > SDR 1000 > 100 watt > tuner > Delta 44 > Dell Optiplex > Windows XP Pro > Pentium 4-3GHz, 1GB Ram > PCI epp/ecp parallel card (port settings are correct) > no USB adapter > no VAC > I can be available for "Log Me In" remote assistance. > > Any advice? Normally a new version might need some tweaking but this doesn't > seem normal. Thanks in advance. > > Mike Monnier > W8BAC > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/