Hi Gang: I have been trying to get a Heil GM-5 Mic and a Heil CC-1 cable to work with the Flex-5000A front panel MIC connector. I did locate a problem with the CC-1 cable there is no connection to PIN 5 of the foster 8 pin MIC connection. Also all the ground connections go to PIN 7 Negative MIC shield and one side of the PTT Foot switch and the PTT on the GM-5. If this is the correct way that Heil has wired the CC-1 connection we will have a problem from others (or maybe they wired my cable wrong). Also the GM-5 has the negative MIC and shield wire connected together inside so that the connector also connects the grounds to the case of the MIC
The Heil GM-5 is wired as the following using a 4 pin connector. Pin 1 - MIC and MIC case ground. Pin 2 + Mic (to capacitor to switch wide narrow) Pin 3 PTT one side of switch Pin 4 PTT other side of switch I found the following with the CC-1 Heil connector Foster 8 pin MIC with foot switch connector wired as follows. Pin 8 + from MIC Pin 7 Negative Mic, Shield, one side of PTT foot switch, one side of PTT GM-5 on the MIC Pin 6 one side of PTT foot switch and one side of PTT on GM-5 on the MIC. Pin 5 NO Connection Pin 4 to 1 No connection. Anybody else have this problem when using the front panel MIC Connection. I also have noted that when you short Pins 5 and 6 on the front panel the FLEX-5000A does not key up?? Have sent Eric W. a email about this. any help will be great Ed WA3BZT -------------- next part -------------- An HTML attachment was scrubbed... URL: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/attachments/20071007/b555ade3/attachment.html _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
