I've noticed that when NB or NB2 are engaged, large (S9+) signals that are outside of the filter end up interacting with the noise blanker causing the noise floor to vary in proportion to the amplitude of the large signal. For example, if clicking the NB results in a 6 dBm decrease in the noise floor, the amplitude changes in the large signal outside of the passband will cause the noise floor within the passband to increase by as much as 6 dBm. It would be nice if the noise blanker could be restricted to only operate within the passband. This wouldn't be an issue if the noise blanker was so darn good on PowerSDR! ;-) Anyone else see this same behavior or do I have something configured wrong?
73, Kurt KC9FOL _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/