First off, your assumption that the SDR-1000 configuration should be applicable is correct. Bob's article is based on VAC 3.x and there is one I wrote based on 4.x in the KB http://kb.flex-radio.com/article.aspx?id=10218
Refer to that article and then check these things. If you are having problems keying, this is probably the issue. 1.) Setup Vcom between PowerSDR and MixW as a CAT interface only. Do not set any of the serial lines to provide keying. RTS and DTR should always be on. Verify the CAT interface is working by the observing the correct frequency readout on the MixW console. 2.) In MixW, configure it to key using CAT. You also want to set the default digi mode to NONE. Also check CW via Soundcard, and ASFK in place of FSK is checked too. -Tim ---- -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Don Sent: Thursday, February 07, 2008 12:03 PM To: flexradio@flex-radio.biz Subject: [Flexradio] MixW & 5000A I am trying to integrate MixW, vcom, vac, and the 5000A. So far I can receive psk and cw and I assume I can also receive rtty. I have configured mixw per n4hy's document though it was written for the 1000 must all applies to the 5000. My problem is that I can not get mixw to key the 5000. I am not quite sure what I am missing. I have setup the com4/5 pair for the 5000 and mixw. Any thoughts? Don - kx9q _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/