There have been a few reports of the RX2 not completing the RX2 calibrations listed in the install instructions. Eric and the crew are aware of it and are working to resolve it.
My RX2 has this problem too. :-( You can try the following. Download the latest version of PowerSDR in /branches/test. Checkout (download) the entire folder and place it into a newly created folder. Do not use a folder that previously contained the PowerSDR program files. You want to download ALL of the files from the branches/test/bin/Release so that all of the files are refreshed. Start PowerSDR which will run the Wisdom configurator and create a brand new database. Configure *only* the sampling rate and audio buffers (96 KHz /1024). Leave all other parameters in the database at their defaults. Connect a dummy load to ANT1. Disconnect all other antennas (including RX2 in) Open the Antenna Selection applet and set it for simple mode, RX1 = ANT1, RX2 = RX1 TAP and TX = ANT1. Select the check box to lock RX and TX to the same antenna. Do not check the box to use the RX1 In/ RX1/Out loop Run the RX2 level calibration test. After the test wait a few seconds to make sure the EEPROM is completely updated. If that passes, run the RX2 image calibration test. Good luck! -Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mark Mumaw Sent: Saturday, June 14, 2008 5:52 PM To: FlexRadio reflector Subject: [Flexradio] RX2 Problem-Help I installed RX2 yesterday but cannot get a successful Level Calibration on all bands. One or more bands always fail but not always the same bands. I have tried recreating .mdb file. I have tried with a dummy load and no antenna. I am using PowerSDR 1.12.0 with 1.2.0.0 firmware. The receiver is basicly working but with sensitivity and image issues. I will call customer support on Monday but I'm hoping someone has some ideas of something to try. Any ideas??????? 73's Mark NU6X Sedona, AZ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
