I want to see if anyone else has reported or is aware of the following problem. It pertains to the Flex 5000A with RX2 installed. When RX1 is in CW mode and RX2 is in either USB or LSB, the RX2 frequency will be off by the CW pitch frequency. For example, if I have RX1 on 6 meter CW and RX 2 is on 20 meters USB, say 14185.0 listening to the guys there, to tune them in I have to go to 14185.5 (.5 KHz is my CW freq). If I change my CW pitch freq to 750 Hz, then I have to tune RX2 in USB mode to 14185.75 to tune them in properly. The same thing happens when RX2 is in LSB as well on, say 80 or 40 meters. When RX1 is in a SSB mode, everything is fine, but this happens every time I have RX1 on CW and RX2 on SSB. W5LUA and I were chatting a bit earlier and I asked Al to see if his 5000 produced the same response and it did. If you have both RX's on SSB and switch RX1 to CW, you will not notice the frequency change in RX2 until you change the frequency. So, if you switch RX1 to CW and move RX2 by 1 Hz it will jump to the CW pitch frequency offset and RX2 will remain in that condition until RX1 is returned to SSB. If RX1 is in LSB and RX2 is on USB everything is fine. It only occurs when RX1 is in CW and RX2 is in SSB. So, has this been experienced before by anyone? Is this a software bug? Inquiring minds need to know!! 73 from your humble Flex Monster Joel W5ZN
_______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
