Don, Contact Dudley ([EMAIL PROTECTED]) for assistance. Opening the radio back up may not be necessary.
-Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Don Sachnoff Sent: Wednesday, September 17, 2008 11:15 PM To: [email protected] Subject: [Flexradio] RFIO Board Installation Well I installed the new RFIO board and it proceeded without issue until I enabled the 2nd RX. The second rx was "dead" not even noise, not even a trace on the scope. I will open it up again and check the cable going to the RFIO board again to make sure it is seated, which is what I did before I buttoned it up. A question, how do I set the 6m tx to ant 1. I know with the previous board it would only transmit on ant 3 for 6m. I am going to assume that is the default with the new board, however, I was under the impression you could change the ant for 6m transmitting to any one of the three ant jacks. Don - kx9q _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
