Well, could somebody in Austin please measure and report back...the RX-TX is a no brainer...most open frame/pin diode/vacuum relays switch faster than the 5000A. If it takes 29ms to break, we might have an issue....
Mike K4EAR -----Original Message----- From: Tim Ellison [mailto:[EMAIL PROTECTED] Sent: Saturday, October 04, 2008 6:06 PM To: Mike Schelly; 'Larry W8ER'; 'Lee A Crocker'; 'Flex Reflector' Subject: RE: [Flexradio] Problem with 5K and Henry Classic With the new firmware, the T/R time has been reduced a little bit, so it should be even lees of a problem. -Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mike Schelly Sent: Saturday, October 04, 2008 6:37 PM To: 'Larry W8ER'; 'Lee A Crocker'; 'Flex Reflector' Subject: Re: [Flexradio] Problem with 5K and Henry Classic According to the ARRL test report the 5000A takes 25ms for RX-TX and 29ms for TX-RX....most any open frame relay in an amp would switch before the 5000A outputs power, I would not think TX delay would be necessary, but would worry about the "break" time...your open frame relay most probably would drop out before the 29ms it takes the 5000A to quit output. A 100ms is bovine scatology............... Mike K4EAR No virus found in this outgoing message. Checked by AVG. Version: 7.5.526 / Virus Database: 270.7.5/1702 - Release Date: 10/1/2008 9:05 AM _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
