You need to reset and recalculate the EEPROM checksum values. Bring up PowerSDR v 1.16.1 Type <SHIFT>+<CTRL>+C In the RX1/PA section, click on the "Reset RX1/PA Checksums" button. When you restart PowerSDR, new checksums will be calculated and you should no longer receive the error.
Be very careful using this EEPROM management form. Do not click on the other buttons without explicit instructions to do so or you could possibly corrupt your EEPROM with bad calibration data. -Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ross Stenberg Sent: Wednesday, December 03, 2008 8:47 AM To: 'FlexRadio reflector' Subject: [Flexradio] 1.3.0.0 and 1.16.1 with SDR-5000 After installing 1.3.0.0 and 1.16.1 upon initialization I get two errors: RX1 Image Gain Checksum Error. DB: A1 EEPROM: A0 Calculated: A1 PA Bridge Checksum Error DB: CB EEPROM: F5 Calculated: CB This occurs after numerous reloads and cycles with a new database. Any ideas? 73 Ross K9COX _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/