i should be able to answer this one but someone should verify it.
click the XVTR's button and assign button zero to the parameters you want
and LO offset if you know it,,,,don't click "xvtr rf tx" at the end.
Then click VHF button front panel to find your created band.
make sure under general you unclick 100w PA present,,,,connect the txvr to
the main HF bnc.
Paul
vk3ddu
I fear that this is a question I should know the answer to, or is in the
manual somewhere, but...
I have a SDR1000 without 100 watt PA. I want to use the HF output at
28-30MHz to drive a transverter. But I want to change the display
frequency to show the transverted frequency. So, using a 70MHz
transverter, I want to transmit on 28.2MHz but have the display show
70.2MHz. How do I do it?
73
David, G4YTL
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage:
http://www.flex-radio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/