I knew the answer would be that I was doing something stupid!!! I had clicked the xvtr rf tx and that prevented it doing what I wanted it to do!
Many thanks Paul David >>> "Paul Radge" <pra...@tpg.com.au> 21/04/2009 11:33 >>> i should be able to answer this one but someone should verify it. click the XVTR's button and assign button zero to the parameters you want and LO offset if you know it,,,,don't click "xvtr rf tx" at the end. Then click VHF button front panel to find your created band. make sure under general you unclick 100w PA present,,,,connect the txvr to the main HF bnc. Paul vk3ddu >I fear that this is a question I should know the answer to, or is in the >manual somewhere, but... > > I have a SDR1000 without 100 watt PA. I want to use the HF output at > 28-30MHz to drive a transverter. But I want to change the display > frequency to show the transverted frequency. So, using a 70MHz > transverter, I want to transmit on 28.2MHz but have the display show > 70.2MHz. How do I do it? > > 73 > > > David, G4YTL > > > _______________________________________________ > FlexRadio Systems Mailing List > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flex-radio.com/ Homepage: > http://www.flex-radio.com/ > > _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
