The following is with both receiver 1 and receiver 2 tuned to 1.590 Mhz - a
strong broadcast signal
It seems to me that the antenna module is not properly switching or that
things aren't connected properly inside the radio .
I'm waiting on the tool to allow me to unscrew the cover to look but in the
meantime I thought I'd ask the group if there are any thoughts about this.
Note that a few days ago I posted a question on the reflector asking how
come receiver 2 had no signal. After moving the radio a bit to get at the
back, receiver 2 started working but had a reduced signal level as well as
not operating properly based upon the antenna selection.
Thanks for your feedback on this
Jim
WD7W
Antenna 1 is a DX-cc Dipole
Antenna 2 is a Mystery Antenna
RX2 in is connected to a taktena
Antenna 3 connector is not connected to anything
Scenario 1
Receiver 1 antenna set to RX1 in
Receiver 2 antenna set to RX1 tap
No signal shown on receiver 1 or receiver 2 as expected
Scenario 2
Receiver 1 antenna set to N/C
Receiver 2 antenna set to N/C
-60db am signal on receiver 1
-85 dp am signal on receiver 2
Scenario 4
Receiver 1 antenna set to Ant1
Receiver 2 antenna set to n/c
-60db am signal on receiver 1
-85 db am signal on receiver 2
Scenario 5
Receiver 1 antenna set to N/C
Receiver 2 antenna set to Ant 1
No signal shown on receiver 1
-85 db am signal on receiver 2
Scenario 6
Receiver 1 antenna set to N/C
Receiver 2 RX1 Tap
-60 db am signal shown on receiver 1
-60 db am signal on receiver 2
Scenario 7
Receiver 1 antenna set to Ant 3
Receiver 2 set to N/C
No signal shown on receiver 1
-85 db on receiver 2
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to arch...@mail-archive.com