Jon, In the future, please post any topics that have to do with experimental software from the SVN repository to the FlexEdge reflector. Including any replies to this post.
As for a possible answer, do a hardware reset of the radio. The instructions for it are in the Knowledge Base. -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jon Sent: Sunday, September 27, 2009 10:45 AM To: [email protected] Subject: [Flexradio] RX2 problem My second receiver all of a sudden (well haven't used it in a while) will only connect to RX1 tap. When I try to connect to RX2 in or Ant 1 while RX1 is on Ant 2 I don't get any signals. It was working OK at one time but a while ago. Is there any software issue that could cause this or do I have a hardware problem. I'm using at the moment F5K, Driver/PAL 3,4,2,6300, Firmware 1.3.0.8, and 1.18.4 SVN 3386 Trunk. Thanks Jon Valdina W2WB _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected] _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected]
