And, every time restart PowerSDR it seems to untick my TX3 setting for 6m and leaves only TX1 ticked? Does it not like using 2 TX ports on 1 band?
-----Original Message----- From: flexradio-boun...@flex-radio.biz [mailto:flexradio-boun...@flex-radio.biz] On Behalf Of Kevin Hobbs Sent: September-04-11 1:11 PM To: flexradio@flex-radio.biz Subject: [Flexradio] Flex-5000A TX1, TX2, TX3 Hi Looking for some further explanation of TX1, TX2, TX3. The manual could still use a little help or a good example. I want to use TX1 and TX2 as a sequencer. I want TX1 to control transmit/receive relays, TX2 to control 8877 amp. I think: TX1 delay 250 TX2 delay 150 Will cause: TX1 to switch 250ms before the Flex actually transmits TX2 to switch 150ms before the Flex actually transmits Resulting in: T/R relay to switch, followed by amp to key 100mS later, followed by Flex to transmit another 150mS later. Is this correct (or backwards)? 73 Kevin _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/