I read all the info on the Knowledge base but it went over some complex setup's and I'm not sure if this will work without damaging my RX2 which I just installed today.
I do have the HRFIO-34 board so I assume this will work. I have 2 antenna's, a small Mosley Mini 33 and a 251' loop for 75m. >From what I have read This set up should work without damaging my RX2 and it should transmit on the appropriate antenna. RX1 set to ANT2 Loop RX2 set to ANT1 Beam TX set to ANT2 Lock box unchecked Now from what I read when I transmit on 75m VFO A it should go out the loop on ANT 2, and if I transmit on 20m VFO B it should transmit out the ANT1 port as the RX2 is set to ANT1 which makes it a Tranceiver Antenna. I hope this makes sense, I am assuming it will work but the example on the knowledge base had a dedicated RX antenna for RX1 and the TX antenna was on ANT3. I hope someone can shed some light on this. I am a bit cautious to try it as I don't want to smoke my new RX2 ! Thanks Craig, W1MSG _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
