Jim, Do a "Reset to Factory Defaults" from the setup screen.
73, Ray, K9DUR http://k9dur.info ==================================== From: Jim Jannuzzo [mailto:jsqu...@msn.com] Sent: Friday, May 04, 2012 1:38 PM To: K9DUR; flexradio@flex-radio.biz Subject: RE: [Flexradio] Frequency adjustment OK, now you've done it. Give the people a little information and they come back for more. I did this, and get the error message "Peak is outside valid range". Am I that far out of calibration? The Panadapter's peak display reads 10.000.009 when the frequency is set to 10.000.000 . There is also a display next to the panadapter peak (bottom right) that reads 8.8 Hz . Align, return, fagedabowdih? Jim KJ2P > From: k9...@rnacs.com > To: kena...@gmail.com; freem...@rogers.com > Date: Fri, 4 May 2012 13:04:06 -0400 > CC: flexradio@flex-radio.biz > Subject: Re: [Flexradio] Frequency adjustment > > Ken, > > No, receiver calibration doesn't do it -- Freq Cal does. > > Michael, > > 1. Tune in WWV on 10MHz. > 2. Open the "Setup" form. > 3. Select the "General" & "Calibration" tabs. > 4. Check the "Expert" box & answer "Yes" to the message that pops up. > 5. Make certain that "Frequency" is set to "10.000000". > 6. Click on "Start". > > That's all there is to it. > > 73, Ray, K9DUR > http://k9dur.info > > > > _______________________________________________ > FlexRadio Systems Mailing List > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/