Thanks for bringing this to our attention. We have found and fixed a bug that was likely causing this and will incorporate this into a future release.
Eric Wachsmann FlexRadio Systems On Wed, Jun 13, 2012 at 9:20 PM, Ronald Bergantzel <ka0r...@yahoo.com>wrote: > Hello !! I was wondering if anyone noticed the following changing power > output conditions..... After running 6 meters using the regular RF output > port ,then switch VFOs , the power out on 2 meters(using XVRTR COM port > )is lower UNTILL I CHANGE the RF output slider down and back to 100 (the > RF power then stays at the normal setting until I change bands). I notice > this occurs on both Power SDR versions - 2.02.2 and 2.3.5 but at varied > amounts.... Has anyone else noticed this on their '1500 ? I have the XVRTR > setting RF output set at 100 .... Is there any other setting that I am > missing ?? Any suggestions would be appreciateed - 73s !! Ron KA0RYT > _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/