Never mind - uninstall and reinstall of PowerSDR fixed the issue - when I installed PowerSDR origionally I did not have a Flex 1500 so the drivers were not available when I first plugged in the1500 - I now have the TurboEncabulator Interfaces installed and radio is working at least on RX. I had to cancel the uninstall and uninstall vspmgr and then restart the install - will see if I can make a contact now!
-Larry On Fri, Jun 29, 2012 at 9:42 PM, Larry da Ponte <n7bcp.la...@gmail.com>wrote: > Hello group - proud owner of a new Flex 1500 but having some install > issues. I'm running a Mac PowerBook 8gb ram, dual core, with win7 64 and > PowerSDR 2.3.5. Upon plugging in the 1500's USB port and powering on the > radio, windows 7 started searching for a driver. It found two drivers but > failed to find two others. The windows dialog shows one USB Composite > Device and four Flex-1500 devices. Three of the 1500 devices failed with > "No driver found" while the last Flex-1500 device says "Flex 1500 Software > Defined Radio" ready to use. So - not sure if that's a failure or a > success but since it said the flex was ready I started PowerSDR and see the > flex radio chooser. The Flex 1500 is not on the list but my Flex 3000 and > 5000 (with their serial numbers showing) are. So - I think the USB is > connected since the driver recognized the radio but PowerSDR is not able to > see the 1500 and let me select it. Suggestions on next steps? > > Thanks > > -- > > 73's > N7BCP > -- 73's N7BCP _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/