Unfortunately, it¹s always been configured to use WDM-KS. -73- Bernie W4BGH -----------
on 9/5/12 2:45 PM, Rich - W3ZJ at r...@w3zj.com wrote: > That's working OK here Bernie. Note that if you had previously configured your > VAC Audio to use MME it is now confgured to use WDM-KS under V2.4.4 and MME > is not available. Thus, you must change the audio Soundcard Driver in CW > Skimmer from MMD to WDM. I tried that with V2.3.5 before installing 2.4.4 and > it worked fine so it was already properly configured when I installed V2.4.4. > As the Flex guys have said quite strongly several times you have to read and > pay attention to the 2.4.4 release notes :-) > > I did have a little trouble with DXLab's WinWarbler because it doesn't like > WDM. But since I feed the power speaker output from the Flex-3000 to the line > input on my computer sound card I was able to configure WinWarbler to get its > audio from the computer sound card instead of the VAC and that seems to be > working OK. I think what we are seeing here is some set up problems because > the Beta testers didn't have duplicates of all our various set ups but so far > it has all been solvable. > > 73, Rich - W3ZJ > > Bernie Huth wrote: >> >> I am not able to get CW Skimmer v 1.71 to decode properly with PowerSDR >> v2.4.4 and a Flex-3000. >> >> > _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/