I hooked up a 10 MHz source to my FLEX-1500 and my two DEMI transverters (L144-28HP and L432-28HP). I heard satellite stations on both FO-29 and VO-52. But when I tried transmitting, I got no drive from the FLEX. After a lot of fiddling around. I noticed that if I used an 18" BNC jumper connected with a barrel to a 36" BNC jumper, the FLEX produced output, but with either jumper alone, I got nothing. Why?
I have the 10 MHz source (Trimble Thunderbolt) connected to a DEMI 10-4 amplifier/filter/4-way splitter. Without the DEMI splitter, I get drive from the FLEX. But with the splitter, I needed the two cables in series. Do you suppose I am getting too much 10 MHz signal from the splitter for the FLEX-1500? And the extra cable length gave me some attenuation? Is the drive level of the 10 MHz signal to the FLEX-1500 critical? Ron _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/