Steve,
First -- N1MM does not support CW via a sound card ( vac ) interface..
Second -- You need to have a CW keying method (serial port pair)
seperate from your CAT and PTT interfaces. In PowerSDR this is
configured in SETUP>DSP>Keying>Connections>Secondary. ( Your Paddles may
use the Primary connections ) In N1MM, the other end of the virtual
serial port pair is configured in Config>Config Ports,...>Hardware
Third -- The CW keying ( and PTT ) is not routed through DDUtil...
DDUtil only supports CAT information.
Hope this helps.
AL, K0VM
On 12/8/2012 12:00 PM, [email protected] wrote:
Date: Sat, 8 Dec 2012 08:01:06 -0700
From: W6SDM Steve<[email protected]>config ports...
To:[email protected]
Subject: [Flexradio] N1MM Keying CW on PowerSDR
Message-ID:
<CAATbXPZ8E5NS8kAc0RKMaorXwOw_m=uzwzoh_qjknufueor...@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
I thought I was pretty good at this... I had PowerSDR, N1MM, and a plethora
of other CAT/VAC based programs working harmoniously together. Last
contest I used N1MM to key CW and it worked liked a charm. I don't
remember changing anything on the system, but obviously I must have tweaked
something.
N1MM will activate the PTT but I get no audio and no CW. It keeps the
radio keyed for the duration of the message, and them releases.
I have looked at the VAC settings, DDUtil looks okay a RCP port set for
N1MM. The N1MM config hasn't been changed. Where should I be looking?
-- Steve Miller w6sdm.net
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
