Thanks for all the help... still searching for the problem though. I did have it working a couple of weeks ago. I worked the 160M CW contest and used N1MM to key the exchange. It worked like a charm. I must have changed something somewhere but I don't know what that is.
I had two serial ports set up - one for PTT and one for CAT. I use the COM 5/15 pair and the COM 6/16 pair. It does key the rig, it's just that there isn't any carrier. VAC1 is always on - the only time I turn it off is when I am using VOX. Still open to suggestions. On Sat, Dec 8, 2012 at 11:44 AM, Al K0VM <[email protected]> wrote: > Steve, > First -- N1MM does not support CW via a sound card ( vac ) interface.. > Second -- You need to have a CW keying method (serial port pair) > seperate from your CAT and PTT interfaces. In PowerSDR this is configured > in SETUP>DSP>Keying>Connections>**Secondary. ( Your Paddles may use the > Primary connections ) In N1MM, the other end of the virtual serial port > pair is configured in Config>Config Ports,...>Hardware > Third -- The CW keying ( and PTT ) is not routed through DDUtil... > DDUtil only supports CAT information. > > Hope this helps. > > AL, K0VM > > > > > On 12/8/2012 12:00 PM, > flexradio-request@flex-radio.**biz<[email protected]>wrote: > >> Date: Sat, 8 Dec 2012 08:01:06 -0700 >> From: W6SDM Steve<[email protected]**>config ports... >> >> To:[email protected] >> Subject: [Flexradio] N1MM Keying CW on PowerSDR >> Message-ID: >> <CAATbXPZ8E5NS8kAc0RKMaorXwOw_**m=uzWzoH_qJKnUfUEORUbA@mail.** >> gmail.com <[email protected]>> >> Content-Type: text/plain; charset=ISO-8859-1 >> >> >> I thought I was pretty good at this... I had PowerSDR, N1MM, and a >> plethora >> of other CAT/VAC based programs working harmoniously together. Last >> contest I used N1MM to key CW and it worked liked a charm. I don't >> remember changing anything on the system, but obviously I must have >> tweaked >> something. >> >> N1MM will activate the PTT but I get no audio and no CW. It keeps the >> radio keyed for the duration of the message, and them releases. >> >> I have looked at the VAC settings, DDUtil looks okay a RCP port set for >> N1MM. The N1MM config hasn't been changed. Where should I be looking? >> >> -- Steve Miller w6sdm.net >> > > -- Steve Miller w6sdm.net _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
