In device manager, click on the device.  Click on the driver tab.  Tell it to 
update and pick the new driver.

If this looks like a foreign language to you, don't do this without help.

Bob


Sent from my iPad

On Jun 26, 2013, at 6:14 PM, John Vandenberg <jvandenbe...@shaw.ca> wrote:

> After updating the software in Win7-64 to  PWRSDR-2.6.4 the TX audio is badly 
> distorted (did try reset database).   The same update on my Win7-32 system 
> worked fine.  When I checked the FW driver in Device manager they are both 
> using the 1394 OHCI Compliant Host controller legacy driver.  I was surprised 
> since I thought it would use the new Flex Firewire driver 4.1.1 .
> 
> The FW card uses the TI chip-set and worked fine in previous versions of 
> PWRSDR.
> 
> I would like to try the new FW driver.  How do I manual install this since it 
> did not do this on the update.
> 
> Note: using DPCLAT or the Flex program I don`t see any bad DPC`s and the Flex 
> program recommend `Normal Mode`
> 
> Any suggestionsÉ
> 
> John, VE3DVV
> 
> _______________________________________________
> FlexRadio Systems Mailing List
> FlexRadio@flex-radio.biz
> http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
> Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
> Knowledge Base: http://kc.flexradio.com/  Homepage: http://www.flexradio.com/

_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/  Homepage: http://www.flexradio.com/

Reply via email to