Just picked up a used Flex-1500. I'm using a remote automatic antenna
tuner, so knowing the SWR seen by the radio is fairly important so I can
tell that the tuner is functioning properly. Setup->Transmit->Tune->TX
Meter gives a selection for SWR, but it doesn't seem to actually do
anything. Setting TX Meter to SWR, applying the changes, and then
clicking on the Tune button shows Fwd Power, not SWR. If you go back
into Setup->Transmit->Tune->TX Meter, it's changed back to Fwd Pwr. If
you change it to SWR, apply the changes, and then return to
Setup->Transmit->Tune->TX Meter w/o hitting the Tune button first, it'll
still be selected to SWR, but after the first time you hit the Tune
button, it'll change itself back to Fwd Pwr.
Any ideas?
73, Ross N4RP
--
FCC Section 97.313(a) “At all times, an amateur station must use the minimum
transmitter power necessary to carry out the desired communications.”
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
