Someone else had this problem when they tried to open a project that had
been closed with print preview open and they deleted the printer that the
print preview was looking for. When you added the printer did you delete
another?
Rob
"Mark E Witherite" <[EMAIL PROTECTED]> on 06/07/2001 11:01:22 AM
Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
cc: (bcc: Rob LaMoreaux/DSPT)
Subject: [PEDA] Locked out of ProtelSE99
Hi Everyone,
Yesterday I added a new printer. All went well and I was able to
print (in another windows program). Now Protel won't open. I get the
error message "invalid printer" when I try to load a schematic. I press
OK and protel locks up. I've tried Other dbb. but get the same results.
Try to use the repair data base and protel closes with out warning. Can
anyone out there steer me in the right direction. Also I have assumed that
the adding of the new printer is what caused the problem. I could be
wrong.
Cheers
mark
Mark Witherite
Assistant Research Engineer
Astronomy & Astrophysics
Penn State University
2565 Park Center Blvd
Suite 200
State College, PA. 16801
email [EMAIL PROTECTED]
telephone 814 865 9839
fax 814 865 9100
IPC PWB Certified
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
