At 01:43 PM 6/7/01 -0500, Tim Hutcheson wrote:
>If you follow the copy component
>instructions to the letter and trying not to corrupt the library, you find
>(at least on my system), that the copied component doesn't appear in the
>Library Editor panel UNTIL YOU SWITCH TO ANOTHER COMPONENT AND SWITCH BACK.
I could not verify this reported behavior. However, I think I understand
it: when a component is copied, it is placed into the list in alphabetical
order. If this causes the new part (which I think is selected by default)
to be off-screen, it does not appear. Switching to another component and
back would force looking through the list and in that case it will be found.
Typically a copied part, if it is being copied into the source library,
will be placed just below the original; I think it is common that the
original will be at the bottom of the pane; the new part will be just
off-screen below the original.
[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
