A clarification -- wiring to ports is not always "just for the viewer". I use "Sheet
symbol/Port connections" with a hierarchical project, and often have unnamed nets
connected to ports.
Dwight Harm
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Monday, June 11, 2001 7:51 AM
3) Whichever end you connect a wire to is the hot spot. Or to be more
accurate whatever net has the same name as the port is the hot spot.
Basically all the port does is say that the net on that page with the same
name as the port goes off the page. No graphical connection required.
<snip>
Ports and Buses are only connected to the nets by the net names, and any
graphical connection is just for the viewer. This is why it will complain
if you have an unnamed net connected to a port, and why a bus between two
sheet entries needs to be named.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
