Dear all, I have a serie of MLX and XMR routers, with Gen1 modules, for non-DFZ routing and MPLS stuffs (LDP/VLL). I have a couple of questions:
1- Can I use NI-MLX-10Gx8-M with an XMR management card ? I have read that it could be possible to mix XMR and MLX cards, with the result that the whole chassis would be "downgraded" to MLX mode, but last time I tried, it didn't work: Does it requires a reload ? Or maybe it's just possible to mix XMR and MLX 10Gx4 linecards, but not with MLX-10Gx8 ? Anyone has tried this ? 2- I am using a combination of NI-MLX-10Gx8-M and NI-MLX-10Gx4 with 1st gen NI-MLX-MR on some non-DFZ routers. Is there some kind of limitation with LACP when mixing ports within those two kind of cards ? I have several issues where one of the port is blocking, for unknown reasons: 12/3 Up LACP-BLOCKED 10G Yes 748e.f85e.1812 xxx#1 [@To CORE:e6/2] 15/4 Up Forward 10G Yes 748e.f85e.1812 xxx#2 [@To CORE:e8/2] I already tried to swap optics on both sides, and ports on remote side I cannot swap port easily on local side, because of some kind of limitations (it's VLL terminations, so it's just impossible to have the same tag-type on a new port, so would have to shutdown the whole lag to be able to do so). I tried to change the linecard, thinking it was faulty, with no more luck. S12 is a NI-MLX-10Gx8-M, and S15 is a NI-MLX-10Gx4, and we are running 5.6. Any experience/feedback would be appreciated :-) Regards Clément _______________________________________________ foundry-nsp mailing list foundry-nsp@puck.nether.net http://puck.nether.net/mailman/listinfo/foundry-nsp