On Wed, Mar 06, 2019 at 11:48:49AM +0100, Clement Cavadore <clem...@cavadore.net> wrote: > > 1- Can I use NI-MLX-10Gx8-M with an XMR management card ? > I have read that it could be possible to mix XMR and MLX cards, with > the result that the whole chassis would be "downgraded" to MLX mode, > but last time I tried, it didn't work: Does it requires a reload ? > Or maybe it's just possible to mix XMR and MLX 10Gx4 linecards, but not > with MLX-10Gx8 ? Anyone has tried this ?
I have never tried this but my understanding that it works this way. What exactly was the problem? The card would not boot up? What does the rconsole say in this case? > 2- I am using a combination of NI-MLX-10Gx8-M and NI-MLX-10Gx4 with 1st > gen NI-MLX-MR on some non-DFZ routers. Is there some kind of limitation > with LACP when mixing ports within those two kind of cards ? I have > several issues where one of the port is blocking, for unknown reasons: > > 12/3 Up LACP-BLOCKED 10G Yes 748e.f85e.1812 xxx#1 [@To CORE:e6/2] > 15/4 Up Forward 10G Yes 748e.f85e.1812 xxx#2 [@To CORE:e8/2] > > I already tried to swap optics on both sides, and ports on remote side > I cannot swap port easily on local side, because of some kind of > limitations (it's VLL terminations, so it's just impossible to have the > same tag-type on a new port, so would have to shutdown the whole lag to > be able to do so). I tried to change the linecard, thinking it was > faulty, with no more luck. What does sh optic report for that port? Is there a signal in both directions? LACP blocked mean port is physically up but LACP does not receive answers from the peer. _______________________________________________ foundry-nsp mailing list foundry-nsp@puck.nether.net http://puck.nether.net/mailman/listinfo/foundry-nsp
