RST is an output pin on the Foxserve board. DS1307 has no matching input pin.
What do you mean by configuring the pins in the kernel configuration? I thought it was just a matter of connecting it to the pins described on page http://www.acmesystems.it/?id=105. Harm --- In [email protected], Xavier Garreau <[EMAIL PROTECTED]> wrote: > > hrmvb a écrit : > > Connections: > > > > DS1307 Foxboard > > ------------------- > > GND J6.40 GND > > SDA J6.32 I2C_DATA > > SCL J6.31 I2C_CLK > > +VCC J7.25 +5V > > > > What did I do wrong? > > What about the RST connection ? > > Moreover, you have to configure the pins used in the kernel configuration. > > regards, > -- > Xavier Garreau <[EMAIL PROTECTED]> > http://www.xgarreau.org/ >
