Kingstone datatravel 512mb with stabilized 5v works perfectly.
________________________________ Da: [email protected] [mailto:[EMAIL PROTECTED] Per conto di xfingerfox32 Inviato: domenica 4 novembre 2007 20.06 A: [email protected] Oggetto: [foxboard] Re: USB memory stick problem - KINGSTON 2GB and 512 MB a bit more information: The foxboard is working at 4.73v loaded, so it could be that KINGSTON is very sensitive, than i got foxboard alone with 5.09v and it took a while to return the same error. SCSI disk error : .... return code = 70000. Error 0x7 is Internal Error. Things get worst with kernel 2.6.15 for the LX832, it refuses to get a valid address and disconnect and tells me to "check cable".. I have 2 classic foxboard and 2 LX832, all the same error. Anyone got a DataTraveler model working with foxboard? I would apprciate any information. Regards, Alexander --- In [email protected] <mailto:foxboard%40yahoogroups.com> , "xfingerfox32" <[EMAIL PROTECTED]> wrote: > > Hello, > > I have read that many of you can mount a memory stick, but i am > unable to do so in kernel 2.4 and 2.6, default fimage or not. > > I am using 2 KINGSTON memory stick, 2 GB and 512 MB, and both fails. > when i mount it "mount -t vfat /dev/sda1 /mnt1" i get the message: > > usb-host.c: USB controller running. > hub.c: new USB device ETRAX 100LX-1, assigned address 2 > scsi0 : SCSI emulation for USB Mass Storage devices > Vendor: Kingston Model: DataTraveler 2.0 Rev: PMAP > Type: Direct-Access ANSI SCSI revision: 02 > Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 > SCSI device sda: 4030464 512-byte hdwr sectors (2064 MB) > sda: Write Protect is off > Partition check: > sda: sda1 sda2 sda3 sda4 > WARNING: USB Mass Storage data integrity not assured > USB Mass Storage device found at 2 > usb-host.c: Got epid attn for bulk endpoint, epid 0 > usb-host.c: Stall for epid 0 > usb-host.c: Completing bulk urb with status -32. > I/O error: dev 08:01, sector 0 > FAT: unable to read boot sector > > I have tried FAT and FAT32, all failed and my linux box reads and > writes fine, also my XP box. > > Perhaps KINGSTON works only on USB 2.0? i dont have any other maker > to try. > > Have anyone get it working? > > If someone can mount it, or have an idea of what i am doing wrong, > please point it out. > > Regards > > Alexander >
