hi there,
I've tried the webcam example from the acme website, also tried
foxServe (with installed webcam support), with a Labtech Pro cam (and
others supported by spca LE). So, no matter what fimage, no matter
what cam, I always get a Kernel Oops after pluging a camera.
Searching the group I found other people asking this, but none of them
got an answer.
Who knows about this problem? Is there a solution for this? Are our
FoxBoards faulty?
Hope someone can help...
thanks,
patrick
here the dmesg dump:
usbcore: registered new driver spca5xx
drivers/usb/media/spca5xx/spca_core.c: spca5xx driver 00.57.06LE
registered
crisv10_irq dbg: ctr_status_irq, controller status: host_mode started
crisv10_irq dbg: ctr_status_irq, controller status: host_mode started
running
usb 1-2: new full speed USB device using hc-crisv10 and address 2
Unable to handle kernel access at virtual address d0070000
Oops: 0000
Stack from c031dd14:
c0005f6c c031de08 c00046b0 c0005cc8 c031de08 00000003 c031de08
c02a0ea0
c015a458 00000000 c031de08 c00047ca d0070000 d0071000 d0070000
c0005492
0000000c c1991e86 00000000 00000018 c1814000 d0071000 d0070000
00000000
Call Trace: [<c0005f6c>] [<c00046b0>] [<c0005cc8>] [<c00047ca>]
[<d0070000>] [<d0071000>] [<d0070000>]
[<c0005492>] [<d0071000>] [<d0070000>] [<c002afb0>]
[<c0149a52>] [<c000978a>] [<d00a8138>] [<c0005aa8>]
[<d0070034>] [<d00a8138>] [<c00d59c8>] [<c00d584c>]
[<d0070036>] [<c00b4096>] [<c00b40e8>] [<c00b3a4c>]
[<d00a8190>] [<c00b4142>] [<c00b3b3c>] [<c00b2f0c>]
[<c00dc5ee>] [<c00d782a>] [<c00d8742>] [<c0080000>]
[<c00d8a94>] [<c00d8b88>] [<c00d8b6c>] [<c000a77c>]
[<c001fea0>] [<c00203fa>] [<c00203fa>] [<c001ff74>]
[<c0006838>]
