Hi Scott, thanx, I have checked my power supply, jumped pin8 but all my efforts were without success. Should ping works with pin8 jumped? Could i reset my board to factory settings? I think no, because my flash should be flash damaged.
Gruß Andreas --- In [email protected], "Scott Lingerfelt" <[EMAIL PROTECTED]> wrote: > > Hi Andreas, > > I am also new to the group and have had a similiar issue with re-flashing > then the board stopped responding! > > I jumped the pin8 as described on the ACMESYSTEMS website and was able to > connect via ethernet. I then used the command line utility to reflash the > board. I had to flash the board twice for some reason then it was back > online. Another thing you might check is the power supply to the board! I > needs to be stable at 5VDC! > > Another possibility was I used two computers and one was running two network > cards and changed to another which only had one and it seemed to work! I do > not know if this had any issue but just sharing my experience. > > Scott > > On 5/20/08, andreas.heisiggabel <[EMAIL PROTECTED]> wrote: > > > > Hello, > > my name is Andreas and i'm new in this forum. > > My problem is, that my lx832 board failed during ftp reflash and the > > led dl1 and dl2 flickers permanently. Also the orange led on ethernet > > flickers. During ftp reflash stage 1 completed with 100% and stage 2 > > stopped at 25% and nothings goes on. At now, there is no possibility > > to connect to the board, neither with ethernet nor with serial > > console. What can i do? > > Any help would be appreciated. > > > > Andreas > > > > > > >
