On Di, 2016-02-23 at 15:58 +0100, Bernd Mueller wrote: > Marc Santhoff wrote: > > > Did you use the stmf103fw.pas translation from Jeppe or make you own > > unit for supporting the 429? > > I needed only a few peripherals (GPIO, USART, RCC and embedded FLASH). I > wrote this stuff by myself.
OK. > > My target would be f407, although the project in mind has to be done > > using an Atmel SAM7 now, programmed in C... :| > > I used the AT91SAM7S256 controller 5 years ago (with fpc 2.3.1 btw). If > I had to use ATMEL, I would look at the SAM3S or SAM4S family. They > should replace the SAM7 which is now over 10 years old. But since ATMEL > has been bought by Microchip, I would avoid them. I know, I know. But it is a low volume device and the chips are in stock. Plus there is the complete compiler and support/HAL-library stuff already done. -- Marc Santhoff <[email protected]> _______________________________________________ fpc-pascal maillist - [email protected] http://lists.freepascal.org/cgi-bin/mailman/listinfo/fpc-pascal
