Avraham Makeler wrote: > I have a table where the whole table jumps to start at the page that > follows > the table's insertion page, so leaving a blank page. So the table's anchor > point is left at the top of the blank page, and the actual table itself > starts at the top of the next page. > > What is going wrong?
Numerous possibilities. Check these: -- In Table Designer, Basic tab, is Start set to Top of Page (or something else causing the same outcome)? -- In the same place, is Orphan Rows set to a number too high to allow the table to break across pages? -- For each row, select Table > Row Format. Check the row's Start Row and Keep With settings. -- In addition, look for possible interactions of these settings. For instance, as others noted, a row can't break across pages. If you row 3 is too tall to fit on the first page, but rows 1 and 2 are set to Keep With Next, or Orphan Rows is set to 3, then FM has to pull the whole thing down a page to conform to the settings. HTH! Richard Richard G. Combs Senior Technical Writer Polycom, Inc. richardDOTcombs AT polycomDOTcom 303-223-5111 ------ rgcombs AT gmailDOTcom 303-777-0436 ------ _______________________________________________ You are currently subscribed to Framers as arch...@mail-archive.com. Send list messages to fram...@lists.frameusers.com. To unsubscribe send a blank email to framers-unsubscr...@lists.frameusers.com or visit http://lists.frameusers.com/mailman/options/framers/archive%40mail-archive.com Send administrative questions to listad...@frameusers.com. Visit http://www.frameusers.com/ for more resources and info.