I am having problems with table cells enlarging table enlarging or contracting based on the amount of data that is flowed into the table cells.
I need for the cells to adhere to the pre-set size set in the table. Is there a setting in FrameMaker that modifies table behavior, allowing table size to adjust based on volume of data? If so, how do I change that setting? Brenda George Desk: (724) 720-8491 bgeorge at federatedinv.com ----------------------------------------- Unless notified to the contrary by the sender, the recipient should consider the contents of this message including any attachments to be confidential. If you are not the intended recipient and have received this message in error, please contact Federated Investors immediately by forwarding this email to notify at federatedinv.com and then delete this message from your system. Saving, copying or disseminating an inadvertently received email could violate state and Federal privacy laws. All emails received by or sent from Federated may be provided to regulators or law enforcement agencies, or used for other purposes consistent with Federated's business interests. Thank you for your cooperation.