"Andrew Reilly" wrote:
> On Fri, Sep 03, 1999 at 09:08:59PM +0100, Doug Rabson wrote:
> > This is no longer necessary (in fact it causes much confusion for the
> > driver). The correct declaration for a pnp soundcard is 'device pcm0'.
>
> How do you set flags for particular cards, now? I used to have
> to use the flags option to tell the pcm driver which second DMA
> channel to use (5: flags 0x15). I haven't had the opportunity
> to do any full-duplex stuff since that change, so I don't know
> whether it has figured it out for itself or not. I assume that
> it has? The boot message now says:
>
> pcm1 (CS423x/Yamaha/AD1816 <CS4236> sn 0xffffffff) at 0x530-0x537 irq 5 drq 1
flags 0x10 on isa
>
> So, is 0 a useful 2nd DMA channel, or does the driver make do
> with one channel now?
I'm not sure, dma 0 works here, but it's specifically detected automatically
(without flags) and is reported as such.
# dmesg | grep pcm
pcm0: <AudioPCI ES1370> irq 11 at device 10.0 on pci0
pcm1: <ESS1868> at port 0x220-0x22f,0x388-0x38b,0x330-0x331 irq 5 drq 1,0 \
on isa0
On another box, I see:
# dmesg | grep pcm
pcm0: <CS4236> at port 0x534-0x537,0x388-0x38b,0x220-0x22f irq 5 drq 1,0 \
on isa0
I suspect this is the same device you have.
Are you sure you are up to date with your source? The probe message
looks a bit odd and looks more like the old pnp messages. Did you rerun
config and do a 'make depend'? Also, the new pnp/pcm code will start at
pcm0, rather than pcm1 unless there is a pcm0 already in use.
Cheers,
-Peter
--
Peter Wemm - [EMAIL PROTECTED]; [EMAIL PROTECTED]; [EMAIL PROTECTED]
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
