Ok, now I would like to get some good info on IPv6 and how it is
structured. Mainly looking for how it works in regards to setting up IP's
and how the IP formatting works. Eg. IPv4 has special blocks of IPs that
are only used for internal networks with there own subnet masks etc.
That kind of info.
Thanks
Shaun
On Sat, 11 Mar 2000, Yoshinobu Inoue wrote:
> > How/Where is the setup for the IPv6?
> >
> > Shaun
>
> If you have recent tree or Freebsd4.0 RC3, then there will be
> IPv6 specific configuration examples in /etc/defaults/rc.conf.
> The lines which start from "ipv6_..." are them.
>
> At least you need to set ipv6_enable to YES.
> You need to add the follwing line into /etc/rc.conf.
>
> ipv6_enable="YES"
>
> If you want to use your machine as IPv6 router, then you need
> to assigne your interfaces IPv6 prefix (like IPv4 subnet).
> Typical configurations will be,
>
> ipv6_gateway_enable="YES" # Set to YES if this host will be a gateway.
> ipv6_router_enable="YES" # Set to YES to enable an IPv6 routing daemon.
> ipv6_router_flags="-l" # Flags to IPv6 routing daemon.
>
> Also, if your router has ed0 and ep0, and you want to assigne
> IPv6 site local prefixes fec0:0000:0000:0001::/64 and
> fec0:0000:0000:0003::/64, then following additions will be enough.
>
> ipv6_network_interfaces="ed0 ep0"
> ipv6_prefix_ed0=fec0:0000:0000:0001
> ipv6_prefix_ep0=fec0:0000:0000:0003
>
>
> Cheers,
> Yoshinobu Inoue
>
>
> To Unsubscribe: send mail to [EMAIL PROTECTED]
> with "unsubscribe freebsd-current" in the body of the message
>
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message