On 31/08/2011 02:40, Nathan Whitehorn wrote:
On 08/30/11 19:07, Ivan Voras wrote:
It was a plain install on a RAID volume which appears as ordinary da0
drive. I did do a couple of start-overs so it could be that some state
got lost. It definitely did NOT show mount points in the dialog which
lists newly created partitions.
Which partitioning scheme did you use? How did you lay out the partitions?
I did not deviate from defaults until the partition editor, where I
deleted existing partitions (Linux) and tried to create new ones.
So, it's a MBR scheme, and I intended to create three partitions, for
"/", for "/srv" and a swap partition. I think Andrey's idea about what
went wrong with the swap partition is most probably correct, so this
only leaves the inability to register mount points with the partitions.
However, if as Brandon suggested this is already fixed, don't bother.
I'll try the BETA2 when ISOs become available and will post screenshots
(IPMI) if it fails again.
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscr...@freebsd.org"
