I just dropped a SoundBlaster Live! card into my box, and have followed
the directions in the handbook and the man pages.
The following lines are in the compiled kernel:
device sound
device snd_emu10k1
I don't get the pcm0 lines that section 7.2.2 in the manual talks
about. cat /dev/sndstat returns:
FreeBSD Audio Driver (newpcm)
Installed devices:
and nothing else.
kldload snd_emu10k1 yields no output whatsoever. When followed by cat
/dev/sndstat it produces the same outputs as above.
kld_load snd_driver yields:
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0x20
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
I recompiled with the sound and emu10k1 drivers commented out, and the
kldload and cat /dev/sndstat commands still yield the same.
I need to get sound enabled on this box, so I can do some online
training provided through streaming video. Please, please, please tell
me I don't have to break down and install wankers on this thing ...
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
