> On Mon, Nov 27, 2006 at 06:58:32PM +0200, Dima wrote: > Hmmm. I am presuming you are booted from an install CD. Yes, I'm booting from install CD.
>> By the way there are some error messages regarding this on Ctrl+Alt+F2 >> (during install), but they say nothing to me: >> ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 >> ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 >> ad0: FAILURE - READ_DMA status=51<READY,DSC,ERROR> >> error=84<ICRC,ABORTED> >> LBA=0 >> They're repeated 4 times. > > Hmmm. > I don't remember seeing anything like those when I had the afore-mentioned > problem. That looks like something is connected wrong or being addressed > wrong. It isn't a geometry issue, I don't think. But Red Hat 9 still works fine on that hardware. What can be wrong? >> My HDD is Master on first IDE-channel, CD-ROM - Secondary on the same >> channel. > > Can you find the dmesg information for both the disk and the CD reader > during the boot? Are they producing device identifiers and specs that > look correct? > Those lines will start with 'adnn:' and 'acdnn:' where nn is a number, > probably '0' (you hope). Yes, I can: ad0: 238457 MB <WDC WD2500JB-00GVC0 08.02D08> at ata0-master UDMA acd0 ..... at ata0-slave looks fine too (I'm too lazy to copy it :) Also I have ad2 and it seems fine on dmesg too. After that goes ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 ad0: WARNING - READ_DMA UDMA ICRC error (retrying request) LBA=0 ad0: FAILURE - READ_DMA status=51<READY,DSC,ERROR> and repeats 3 times. _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
