Hello. I am testing out a new tyan motherboard that uses the next generation of AMD chips and the Serverworks Chipset. It seems that I can reliably crash it with a simple bonnie++ test if I set:
/boot/loader.conf - Used for DiskD for Squid kern.ipc.msgtql=2048 I am using FreeBSD 6.1-STABLE amd64. This all works just fine on a non Serverworks Chipset Tyan Board. (literaly I unplug the drive and move it to another system and it works and works in production) If I run: bonnie++ -d /home -u root s1g The system reboots. I have tried this is both S-ATA and P-ATA emulation. Any ideas on why this setting, which works on non Serverworks boards, would make the Serverworks so twitchy? Thanks Nicole atapci0: <ServerWorks HT1000 SATA150 controller> port 0xb080-0xb087,0xb000-0xb003,0xac00-0xac07 ,0xa880-0xa883,0xa800-0xa81f mem 0xff4fe000-0xff4fffff irq 11 at device 14.0 on pci1 S-ATA: ad4: 70911MB <WDC WD740ADFD-00NLR1 20.07P20> at ata2-master SATA150 OR P-ATA: ad4: DMA limited to UDMA33, device found non-ATA66 cable ad4: 70911MB <WDC WD740ADFD-00NLR1 20.07P20> at ata2-master UDMA33 /boot/loader.conf kern.ipc.msgtql=2048 _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"