On Tue, May 15, 2012 at 12:51:04AM -0400, Benjamin Kaduk wrote: Hello Ben,
Thank you for your response. I cleaned and then copied the 82 file to 83 and then edited it to replace all 82-s with 83 or added it where there seemed to be a list of versions. It got a lot further, but now dies not finding another file. ../rpc/types.h:77:27: error: rpc/netconfig.h: No such file or directory I will send along another message with the build script attached. > Hi Jerry, > > On Mon, 14 May 2012, Jerry McAllister wrote: > > >Hi, > > > >I installed AMD64 FreeBSD 8.3 on a new machine a couple of days ago. > >It seems fine so far. > > > >This afternoon I tried to install OpenAFS 1.6.0 on it from > > /usr/ports/net/openafs > > > >The configure ran happily and I didn't notice any errors. > >But, the make died soon after starting with the following complaints. > > > > make: don't know how to make ./param.amd64_fbsd_83.h. stop > > *** Error code 2 > > > > Stop in /usr/ports/net/openafs/work/openafs-1.6.0. > > ** Error code 1 > > > >I presume that means that it does not know about FreeBSD 8.3 yet. > > That's right; the OpenAFS build system has lots of history behind it, > which means that it is not particularly elegant at handling this sort of > thing. A lot of history. We have used it at MSU for a long time. It was never my project to build or maintain, but I used it a lot. > > >I rummaged around in the README it left in the ../work directory > >and saw a bunch of AMD64 versions up to 8.1 (and even 9.0) but > >not 8.2 or 8.3. I noticed in the Makefile where it says: > > IGNORE= Supports FreeBSD 8.0 and later > >I am not sure how that plays in it. I am definitely not a make hacker. > > > >Anyway, is there a good tinker to get past this > >or do I have to wait until something gets updated in the port? > > > >Or, did I just do something stupid? > > No fault on your end; I need to push in updates for 8.3 and 10.0 support > but have been busy with schoolwork. I can sure relate to that. > For now, if you're up for a little bit of tinkering, you could go in to > /usr/ports/net/openafs and 'make clean && make extract', then: > cd work/openafs-1.6.0/src/config && cp param.amd64_fbsd_82.h > param.amd64_fbsd_83.h > and continue with the usual make install, etc., in > /usr/ports/net/openafs/. > If that still does not compile/run, please send me the build log (or > dmesg -a output if a runtime failure) and I will look at it. > > Thanks for the report, and sorry to have been so slow at catching up to > 8.3/10.0. > > -Ben Kaduk Thanks for your help, ////jerry _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"