Le 05/03/2004 à 22:05:25-0700, Scott Long a écrit > On Sun, 29 Feb 2004, Chad Leigh -- Shire.Net LLC wrote: > > > > Now the machine, when it tries to check the two aacd volumes on this > > controller, starts printing out this message below every 20 seconds or > > so and the disk volumes cannot be used. Each new IO attempt triggers a > > new set of these messages. The hex number after the COMMAND word is > > different for each new IO request but of course stays the same for > > repeated messages relating to the same original IO request > > > > aac0: COMMAND 0xc551a7e8 TIMEOUT AFTER 147 SECONDS > > > > I have googled on this and similar posts related to 2120S controllers > > all seemed to have different causes and fixes... > > I thought that 5.2.1 would have fixed all of this. This isn't good. > > > Any hints or ideas on what is causing this? I can get into the > > controller at POST time and it checks out... > > Can you boot the machine at all? If so, could I feed you some patches to > help diagnose the problem? >
Long time ago (humm 3 mounths ;-)) ) I've same problem with a Adaptec 2120S on FreeBSD 5.2 The reconstruction don't work and sometime the machin hang up with same kind of message. I solve the problem (after many time) by to remove the SCSI terminator on the array (where I put the hot-plug disk). Hope this help. Regards. -- Albert SHIH Universite de Paris 7 (Denis DIDEROT) U.F.R. de Mathematiques. Heure local/Local time: Wed Mar 17 10:29:24 CET 2004 _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"