On Tue, 4 May 2004, Florian wrote: > On advice, I downloaded FreeBSD 4.10 RC2 (because 5.2.1 would not work) > but can't install it because the installer does not find my HDD which is a > 120gb Seagate drive on an on-board Silicon Image SiI 3112 SATARaid > Controller. > Is SATA support not yet implemented in RC2 but in the 4.9? Or is SATA only > supported in 5.x? > What can I do?
I just finished upgrading a system to a new motherboard with SATA. To do that, I loaded a normal parallel IDE drive, installed to it, and then used dump to move the install over to the SATA drive. Editing /etc/fstab to use ad4 instead of ad0 was the next step, and then finally setting the BIOS to boot from the SATA drive. -Warren Block * Rapid City, South Dakota USA _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
