On 17/04/2012, at 2:32 AM, Doug Ambrisko wrote: > Jan Mikkelsen writes: > | On 31/03/2012, at 1:14 AM, Doug Ambrisko wrote: ... > | > Yes, this card is supported with the mfi(4) in projects/head_mfi. Looks > | > like we fixed a couple of last minute found bugs when trying to create a > | > RAID wth mfiutil. This should be fixed now. I'm going to start the > | > merge to -current today. The version in head_mfi can run on older > | > versions of FreeBSD with the changes that Sean did. > | > | I have just imported the mfi(4) and mfiutil(8) into a 9.0-RELEASE tree to > | try this out. > | > | When booting up with two fresh drives attached, they show up as usable > | JBOD disks. However, I cannot use mfiutil to create anything with them. > | Every drive gives > | > | "mfiutil: Drive n not available" > > You might want to include the output of: > mfiutil show drives > and then the command you are trying to do to create a RAID with. > > | Is this expected behaviour? How can I create a raid1 volume using > | mfiutil and clean disks? > > I'm not sure if mfiutil can switch disks from JBOD mode to RAID. > I don't see any reason why it shouldn't. It can't go from RAID to > real JBOD mode since it doesn't have code to support that. > > | I tried using MegaCli from the LSI website (versions 8.02.16 and > | 8.02.21), but they can't even detect the controller. I know you > | said at some point that a very recent version of MegaCli was > | required. What version is necessary? > > What was the syntax you used since usage is cryptic? I've never > seen a MegaCli that couldn't access the card. What I meant by > more recent MegaCli is earlier versions didn't have the JBOD > commands in it. I have a 8.00.46 that knows about JBOD.
The MegaCli problem was an embarrassing operator error which I can't blame on the bad UI. "mfiutil create jbod …" doesn't create a JBOD disk, it creates a raid0 volume. I think that was expected. The biggest problem with this controller and just mfiutil is that you can't get a drive from the JBOD state to the unconfigured-good state, and a blank disk starts in JBOD. So to do any setup you need to resort to the BIOS utility or MegaCli. For each disk to change from JBOD to "Unconfigured-good" so that it can be used to create a volume, I needed to do: MegaCli -PDMakeGood -Physdrv '[64:1]' -force -a0 Obviously with the right drivespec. Once they're in this state I can use mfiutil to create volumes. I can get drives from the unconfigured-good state to JBOD by doing "MegaCli -PDMakeJBOD …". This is just in a little test machine with a few drives. Now that it is working to this level I will get a server with a 9240 and give it a proper run. I'll also try the driver out in one of the 9261 based servers we've got here. Thanks! Jan. _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "freebsd-stable-unsubscr...@freebsd.org"