> Michael C. Shultz wrote: > >I have one IDE and two SATA drives in my system. With > >FreeBSD 5.4 the system would not boot from the SATA > >drive so I use the IDE as the primary then mount > >the SATA drives in fstab. I tried upgrading to RELENG_6 > >and with the new kernel one of the SATA drives errors > >out and so can't be mounted. I don't have the error message > >using the 6.0 kernel but here is dmesg from 5.4 if it helps: > > > >ad4: 76319MB <WDC WD800JD-00HKA0/13.03G13> [155061/16/63] at ata2-master > >SATA150 > >ad6: 114473MB <WDC WD1200JD-00HBB0/08.02D08> [232581/16/63] at ata3-master > >SATA150 > > > >It is at4 that is failing with 6.0, this drive never gives any problem > > under 5.4. Both SATA drives are plugged into the same really cheap addon > > pci card. > > > >I'll be happy to provide more detail if requested and I'm able. > > > >Thank you, > > > >-Mike > >
On Tuesday 12 July 2005 11:36, Jayton Garnett wrote: > Are you using the correct cables? I had a problem when I changed system > cases and used the wrong cable when I put the drives back in (IDE cable > instead of a SATA cable) I now have FreeBSD 5.4-p3 booting up fine and > without error. I think this is a common problem, where people forget > about the minor details(I am sure we are all guilty of this at some time) Perhaps I was not clear in the original message: Both SATA drives work under 5.4, only one works under 6.0. -Mike _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"